Question: Where do you run surround sound wires?

Carefully drill a hole at the base of your wall behind your AV gear or speakers and run the wire up—connecting it to the back of your speaker connector wall plate. Now youll have a completely finished look that is much nicer than having speaker wiring simply duck into the carpet at the baseboard.

How do you run speaker wire through walls?

0:492:10How to Run Speaker Wire Through Walls - YouTubeYouTubeStart of suggested clipEnd of suggested clipLike so and this has these little flip out tabs that hold it up against the inside of the drywall.MoreLike so and this has these little flip out tabs that hold it up against the inside of the drywall. Take your screwdriver tighten it up. And then it cinches up against the wall.

How do I manage my surround sound with cable?

5:116:19Tech Tips: How to manage your home theater cables. - YouTubeYouTubeStart of suggested clipEnd of suggested clipSolution just running cables behind your equipment. And keeping them low will help give a neaterMoreSolution just running cables behind your equipment. And keeping them low will help give a neater look and you can always just use a few cable tie anchors or cable ties to keep them in place.

How do I hook up my surround sound to my receiver?

Connect a Coaxial Digital Cable, Optical Digital Cable, or Audio cable to the Audio Output jack on your TV. Connect the other end of the cable to the corresponding jacks on the A/V receiver or home theater system. Depending on your device, the audio input may be labeled TV INPUT or VIDEO INPUT.

How do I control my subwoofer cable?

2:569:20Ultimate Cable Management - Home Theater Hack - YouTubeYouTube

Join us

Find us at the office

Drum- Kolsky street no. 57, 62517 Manama, Bahrain

Give us a ring

Henrick Wertman
+47 414 731 31
Mon - Fri, 11:00-17:00

Tell us about you